Gearbox Oil; Engine Coolant; Coolant Level - BOMBARDIER outlander max 800 Operator's Manual

To add oil, remove dipstick. Place a funnel
into the dipstick tube to avoid spillage.
Add a small amount of recommended oil and
recheck oil level.
Repeat the above procedures until oil level
reaches the dipstick's upper mark. Do not
overfill.
Properly tighten dipstick.

Gearbox Oil

Recommended Oil
Use XP-S chaincase oil (P/N 413 801 900) or
an equivalent.
CAUTION: Do not use unrecommended oth-
er types of oil when servicing. Do not mix with
other types of oil.
Gearbox Oil Level
CAUTION: Check level and refill if necessary.
Do not overfill. Operating the gearbox with an
improper level may severely damage gear-
box. Wipe off any spillage.
Place the vehicle on a level surface. Select
NEUTRAL position then apply parking brake.
Check the gearbox oil level by removing the
gearbox oil level plug.
1. Oil level plug
2. Oil drain plug
The oil should be level with the bottom of the
oil level hole. Refill as required until gearbox
oil level flows through oil level hole.
To change gearbox oil, refer to MAINTE-
NANCE section.
104

Engine Coolant

Recommended Coolant
Always use ethylene-glycol antifreeze con-
taining corrosion inhibitors specifically for in-
ternal combustion aluminum engines.
C o o l i n g s y s t e m m u s t b e f i l l e d w i t h
Bombardier premixed coolant (P/N 219 700
362) or with distilled water and antifreeze so-
lution (50% distilled water, 50% antifreeze).

Coolant Level

WARNING
Check coolant level with engine cold. Nev-
er add coolant in cooling system when en-
gine is hot.
Remove access panel.
TYPICAL
With vehicle on a level surface, liquid should
be between MIN. and MAX. level marks of
coolant reservoir.
NOTE: When checking level at temperature
lower than 20°C (68°F), it may be slightly low-
er than MIN. mark.