Download Print this page

Safety Information - Heatscope MHS-VT1600WT.100 Installation And Instruction Manual

Heatscope spot, heatscope vision
Hide thumbs Also See for MHS-VT1600WT.100:

Advertisement

Available languages

Available languages

M U N I C H H O M E S Y S T E M S

Safety iNformatioN

HeatSCoPe® infrared heaters must be installed and executed only by an authorized expert / profes-
sional electrician.
All relevant local building and fire safety regulations must be observed.
WARNING: This unit is not equipped with an application to regulate the room temperature. the
heater must not be used in small rooms inhabited by people who cannot leave the room unaided,
unless constant supervision is ensured.
Be careful when operating the unit. Children younger than 3 years must be kept away, unless they
are overseen all the time. Children older than 3 years and younger than 8 years are allowed to
switch on and off the unit, if they are overseen, or if they were instructed how to use the unit safely
and have received instructions how to operate/use the unit, assumed the unit is installed properly.
CAUTION: Some parts of the unit get very hot and may cause burns! High cautiousness is imperative,
if children or persons with reduced physical, sensory or mental abilities or lack of experience and/or
knowledge. are present in the room.
Children older than 3 years and younger than 8 years are not allowed to connect the plug, to control
the unit, to clean the unit and/or to maintain the unit.
Children older than 8 years and persons with reduced physical, sensory or mental abilities or lack of
experience and/or knowledge can use this unit, if they are overseen, or if they were instructed how
to use the unit safely and have received instructions how to operate/use the unit and which endan-
germents may result during the use of the unit. Children must not be playing with the unit. Cleaning
and maintenance must not be done by children, unless they are supervised by a person responsible
for their safety.
The unit must never be used unattended. Children must be supervised at all times to ensure that
they do not play with the unit, switch it on unintentionally or adjust it.
1. Please check that your HEATSCOPE® radiant heater and accessories are complete and not damaged.
In special take care of the glass holders of the model range VISION, which hold and surround the glass
ceramic front screen. Press the holders carefully back in position, untill they click into place again.
If the housing or reflector is deformed/damaged or the heating element is broken, do not use the
HEATSCOPE® unit. Please contact the vendor or the manufacturer.
The cable must not be crushed, squeezed or damaged.
If the unit or accessories show signs of defects, cracking, breakage or other damage or if the industrial
glass ceramics screen is damaged, discontinue use and have them repaired. In this case, disconnect the
unit from the power supply, return it to the manufacturer or dispose of it. The unit should be labelled
accordingly to prevent it being reconnected.
2. For installation use only the supplied accessories or original accessories approved by the manufactu-
rer. The power cable or other components of the HEATSCOPE® radiant heater may only be replaced by
a professional servicing company enlisted by the manufacturer.
3. The HEATSCOPE® has an IP X4 protection class rating (protected against objects >1mm and splashing
water). Nevertheless, it is mandatory to install the unit on a surface where it is well protected from any
US
GreenChance inc. · 11265 Washington Blvd. · USA CA90230

Advertisement

loading