Omron C200HW-CLK21 Operation Manual page 99

Wiring
Note
Connection Procedure
1,2,3...
76
CS1W-RPT03 (GI)
Wired Controller
Link Unit
CS1W-RPT03
Repeater Unit
1. Always use the specified Optical Fiber Cables.
2. Although the Optical Fiber Cables can be distinguished by the markings or
color, in order to prevent incorrect connection it is recommended that tags
are attached to the cables.
3. The maximum distance between nodes depends on the type of GI cable
(core diameter) that is being used.
62.5/125 m cable: Max. distance between nodes = 2 km
50/125 m cable: Max. distance between nodes = 1 km
Use the following procedure to connect Optical Fiber Cables to a Unit.
1. Attach the mounting bracket to the Unit with the provided screws.
2. Attach the clamp to the mounting bracket so that it clamps the cable(s).
3. Remove the Optical Connector Covers from the Unit's connectors shown
in the following diagram if there are covers protecting the connectors.
SL1
GI cable
Receive Receive
Send
Send
SL2
CS1W-RPT03
Repeater Unit
1. Screw the mounting
bracket to the Unit.
Mounting bracket
2. Attach the clamp to the
mounting bracket so that
the cable(s) are clamped.
Clamp
Section 3-3
SL1
Wired Controller
Link Unit
SL2