Omron C200HW-CLK21 Operation Manual page 47

Specifications and Configurations
Controller Link Support Software Menu Overview
Menu items:
CX-Programmer
24
Data Link
Set Network parameters
Routing tables
Echoback test
Broadcast test
Monitor Network
Display Error log
Display Node status
Display Board setup
Maintenance
Connection Info*
Edit PC ID
System setup
Note 1. Refer to the Controller Link Support Software Operation Manual (W308)
for detailed operating procedures.
2. Use the CX-Net in CX-Programmer version 5.0 or higher to set data link
areas in which the number of send and receive words exceeds 12,000, or
to set data link tables that allocate the same area for Area 1 and Area 2.
Controller Link Support Software cannot be used for these settings.
3. For automatic data link creation with 1:N allocations or when changing
data link tables while the data link is active (CS1W-CLK21-V1 and CJ1W-
CLK21-V1), use the CX-Net in CX-Programmer version 3.2 or higher. Con-
troller LInk Support Software cannot be used to perform these functions.
The CX-Net operations within the CX-Programmer is required when using
user-set data links, or when setting or monitoring detailed settings of the Con-
troller Link Unit. This software can be used with a CS/CJ-series PLC and is
ideal for the following applications.
• Setting the data link mode to "manual" (creating and storing data link
tables).
• Starting/stopping data links.
• Reading (monitoring) network status.
• Reading error logs.
• Setting routing tables.
• Testing the Network.
• Changing network parameters.
Edit table Save table
Copy table Retrieve table
Initialize table Transfer table
Check table Delete table
Unit backup
Board backup
Initialize network parameters
*Optical Ring Link Systems only.
Section 1-2
Print table
Start/Stop
Monitor status
Device info set