Omron C200HW-CLK21 Operation Manual page 340

Error Log
Error Contents
code
0109 Transmission failed; destination
Hex busy
010A Transmission failed; communica-
Hex tions controller error
010B Transmission failed; PLC error
Hex
010C Transmission failed; unit number
Hex incorrect
010D Transmission failed; destination
Hex address incorrect
010E Transmission failed; routing
Hex tables not registered
010F Transmission failed; routing table
Hex error
0110 Transmission failed; too many
Hex relay points
0111 Transmission failed; command
Hex packet too long
0112 Transmission failed; header
Hex error.
0113 Transmission failed; I/O setting
Hex error
0114 Transmission failed; CPU bus
Hex error
0115 Transmission failed; redundant I/
Hex O allocations
0116 Transmission failed; CPU Bus
Hex Unit error
Detail code
1st byte 2nd byte
Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node
address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Correction Written to
EEPROM
Increase number of No
retries or reconfig-
ure system to distrib-
ute load.
Conduct an echo- Yes
back test and if the
effects of noise are
considerable, recon-
sider the operating
environment. Restart
the Controller Link
Unit. If the error
occurs again,
replace the Unit.
Refer to the PLC No
operating manual. If
the error occurs
again, replace the
PLC.
Check unit number No
settings to be sure
they are within range
and unique.
Check routing tables. No
Check routing tables No
Check routing tables. No
Check routing tables No
and system configu-
ration. Use a CS/CJ-
series CPU Unit with
unit version 2.0 or
later and CX-Pro-
grammer Ver. 4.0 or
higher to send com-
mands across three
or more network lev-
els.
Be sure to use the No
FINS command
format.
Be sure to use the No
correct FINS
command format.
Check I/O table No
accuracy.
Check Unit and cable No
connections and
clear error.
Check unit numbers No
for redundancy within
the same PLC.
Check Unit and cable No
connections and
clear error.
Section 9-3
Applicable
PLC
All
All
All
CV, CS/CJ
All
All
All
All
All
All
CV, CS/CJ
CV, CS/CJ
CV, CS/CJ
CV, CS/CJ
317