Omron C200HW-CLK21 Operation Manual page 206

Introduction
Example: Commands for CVM1, CV-series and CS/CJ-series PLCs
curring by performing resend processing at the node where instructions
are issued. With the SEND, RECV, and CMND instructions, resend pro-
cessing is performed automatically once the number of retries has been
set, so be sure to specify a number other than "0" for the number of retries.
Type of command
For memory areas (CIO,
DM, EM, TC, transition, step,
forced ON/OFF)
For parameter areas (PLC
system setting, I/O table reg-
istration, routing table, etc.)
For program areas (UM)
PLC mode
PLC model data
PLC status data
PLC internal clock
Messages
Access rights
Error data
MEMORY AREA READ
MEMORY AREA WRITE
MEMORY AREA FILL
MULTIPLE MEMORY AREA
READ
MEMORY AREA TRANS-
FER
PARAMETER AREA READ
PARAMETER AREA WRITE 0202
PARAMETER AREA CLEAR 0203
PROGRAM AREA PRO-
TECT
PROGRAM AREA PRO-
TECT CLEAR
PROGRAM AREA READ
PROGRAM AREA WRITE
PROGRAM AREA CLEAR
RUN
STOP
CONTROLLER DATA READ 0501
CONNECTION DATA READ 0502
CONTROLLER STATUS
READ
CYCLE TIME READ
CLOCK READ
CLOCK WRITE
MESSAGE READ
MESSAGE CLEAR
FAL/FALS READ
ACCESS RIGHT ACQUIRE
ACCESS RIGHT FORCED
ACQUIRE
ACCESS RIGHT RELEASE 0C03
ERROR CLEAR
ERROR LOG READ
ERROR LOG CLEAR
Section 6-1
Code CS/ CVM1/
CJ CV
0101 Yes Yes
0102 Yes Yes
0103 Yes Yes
0104 Yes Yes
0105 Yes Yes
0201 Yes Yes
Yes Yes
Yes Yes
0304 Yes Yes
0305 Yes Yes
0306 Yes Yes
0307 Yes Yes
0308 Yes Yes
0401 Yes Yes
0402 Yes Yes
Yes Yes
Yes Yes
0601 Yes Yes
0620 Yes Yes
0701 Yes Yes
0702 Yes Yes
0920 Yes Yes
Yes Yes
Yes Yes
0C01 Yes Yes
0C02 Yes Yes
Yes Yes
2101 Yes Yes
2102 Yes Yes
2103 Yes Yes
183