Operating The Blender; After Use - Russell Hobbs 20230AU Instructions & Warranty

PLACING THE GLASS JUG ON THE MOTOR UNIT
• Check that the speed control is set to 'O' off.
• Align on the jug base with
• Lower the jug on to the motor unit, ensure it is seated correctly, then turn the jug to align
on the jug base with
• You should hear it click into place.

OPERATING THE BLENDER

• Sit the blender on a stable, level, dry surface.
• Place the ingredients you wish to blend into the glass jug.
IMPORTANT: Do not fill it past the 1250ml mark. If you do, the contents may force the lid
off when starting the motor.
• Fit the lid onto the jug. Press down firmly.
• Insert the cap into the opening of the lid by aligning the cap tabs with the notches in the lid
opening. Turn it in a clockwise direction to lock it in place.
NOTE: Do not run the blender without the cap, as ingredients may be ejected through the
hole.
• Place your hand on top of the blender jug lid to hold the jug steady. Switch the motor
unit on to the desired speed or pulse setting using the speed control. Refer to the Speed
Selection Guide on page 8 for ideal speed settings to match your blending task.
NOTE: The speed control must be held in the 'P' position for the motor to run. When the
switch is released, the motor will stop.
NOTE: See section SPEED SELECTION GUIDE on page 8 for more information.
IMPORTANT:
• The Lid MUST ALWAYS be in place before starting the Blender.
• Do not run the motor for longer than 1 minute. After 1 minute, switch off for at least
2 minutes to allow the motor to cool down.
• When blending cooked ingredients always let them cool for at least 10 minutes
before blending. Pouring boiling liquids into a cold glass jug could cause the jug to
crack. Liquids and ingredients should be below 40°C.

AFTER USE

• Turn the speed selector dial to the 'O' off position and wait until the blades stop moving.
• Switch the power off and remove the plug from the wall power outlet.
on the motor unit.
on the motor unit.
6