Advertisement
PARTS
1.
Speed control
2.
Motor unit
3.
Blade unit
4.
Seal
PREPARATION
1.
Sit the motor unit on a stable, level surface.
Align the d on the bottom of the jug with the U on the motor unit.
2.
3.
Lower the jug on to the motor unit, then turn the jug to align the d with the L.
4.
Turn the lid anti-clockwise to unlock it then lift it off the jug.
5.
Put the ingredients into the jug.
6.
Don't fill past the 1500ml mark. If you do, the contents may force the lid off
when you start the motor.
7.
Place the lid onto the jug with the tab as shown in figure A.
8.
Twist the lid clockwise to lock it (fig. B)
9.
Push the cap into the hole in the lid.
10.
Don't run the appliance without fitting the cap.
Check that the speed control is set to 0.
11.
12.
Put the plug into the power socket.
USING YOUR BLENDER
•
Don't run the motor continuously for more than 3 minutes because it may
overheat. After 3 minutes switch off for at least 10 minutes to allow the motor
to cool.
•
Your blender will stop operating if it overheats. If this happens, unplug your
blender and let it cool down for at least 15 minutes before using it again.
1.
Turn the speed control to the speed you want (1 = low, 2 = high).
Turn the speed control back to 0 to turn the motor off.
2.
3.
Generally, large quantities, thick mixes, and a high ratio of solids to liquids
suggest longer timings and slower speeds.
4.
Smaller quantities, thinner mixes, and more liquids than solids suggest shorter
timings and higher speeds.
5.
Don't run the motor for more than 1 minute, or it may overheat. After 1 minute,
switch off for at least 2 minutes, to let the motor cool.
5.
Jug
6.
Lid
7.
Cap
8.
Tab
4
Advertisement
