Before Using For The First Time; Blender Assembly Instructions - Russell Hobbs RHBLRET Instructions Manual

Getting to Know Your Russell Hobbs®
3 Speed Blender
Product may vary slightly from illustrations.

Before Using for the First Time

CAUTION: Use extreme care when handling the Blade Assembly. Do not
touch the Blades with your fingers. The Blades are very sharp and
can cause injury if touched.
1. Carefully unpack the Blender, Blending Jar, and all parts.
2. Wash the Measuring Cap, Rubber Seal Ring, Blending Jar, Blending Jar
Lid, and Blade Assembly in warm soapy water. Rinse and dry thoroughly.
3. Make sure the cord is unplugged and the Speed Control Dial is turned to
"0" , the OFF position.
CAUTION: To protect against risk of electrical shock, do not place Motor
Housing, plug or cord in water or any other liquid.
4. Wipe the Motor Housing clean with a moistened cloth. Dry thoroughly.

Blender Assembly Instructions

NOTE: Before assembling, make sure the cord is unplugged and the
Speed Control Dial is turned to "0" , the OFF position.
CAUTION: Use extreme care when handling the Blade Assembly. Do not
touch Blades with your fingers. The Blades are very sharp and can
cause injury if touched.
Figure 1
10. Power Cord with
11. PULSE Button
3
1. Measuring Cap
(P/N 71238)
2. Blending Jar Lid
(P/N 71239)
3. Blending Jar
(P/N 71240)
4. Rubber Seal Ring
(P/N 71241)
5. Blade Assembly
(P/N 71242)
6. Motor Housing
7. Speed Display
8. Speed Control Dial
9. Non-Slip Rubber
Feet
Polarized Plug