Table of Contents
Advertisement
3.4.5.4
Updating the NMM Firmware via FTP
Using an FTP application, upload the new firmware into the FTP root directory of the NMM. When the file
transfer is complete, the NMM verifies the file and then automatically restarts with the newly loaded
firmware.
For detailed instructions on updating the management modules and other modules in the same chassis via
FTP, download the application note "iConverter Management: Updating Modules via FTP" available on
Omnitron's web page:
http://www.omnitron-systems.com/downloads.php
See Setting NMM Passwords, Section 3.4.1.4, on how to configure FTP.
3.5
VERIFY OPERATION
Once the module has been installed and configured, per Sections 3.2 - 3.4, verify the module is operational
by viewing the status of the LED indicators. The table below provides a description for each indicator.
The Power LED indicates the module is receiving power from the chassis. The NMM has an LED indicator
for each available power supply in the chassis (19-Module Chassis has three, 5-Module Chassis has two).
The Master/Slave and Management LEDs indicate the operation and configuration of the management
channel. A blinking "Mgt" LED indicates the NMM is polling the chassis.
The UTP "Lk/Rx" LED indicates the module has established a connection across its UTP port. A blinking
LED indicates the presence of data.
Refer to Section 6.0, Troubleshooting Guide, for help in determining possible fault conditions.
LED Function
"Legend"
Power "Pwr"
Power Supply
#1 Status
"PS1"
Power Supply
#2 Status
"PS2"
Power Supply
#3 Status
"PS3"
Management
Mode "Msr/Slv"
Management
Polling "Mgt"
Management
Port Link and
Activity "Lk/Rx"
Color
Off State
Amber No power
Power Supply #1 not
Amber
installed
Power Supply #2 not
Amber
installed
Power Supply #3 not
Amber
installed
Network Ports Status
Green Slave Mode
Green No Polling Activity
Green No Link
On / Blinking State
Module has power
On: Power available from installed Power
Supply #1
Blinking: No power available from installed
Power Supply #1
On: Power available from installed Power
Supply #2
Blinking: No power available from installed
Power Supply #2
On: Power available from installed Power
Supply #3
Blinking: No power available from installed
Power Supply #3
Master Mode
Management Polling Activity
On: 10Mbps UTP Port Link is active (via
either UTP or Backplane Port A)
Blinking: UTP Port Data Activity
Page 20
Advertisement
Table of Contents
