TRENDnet User's Guide
SNMP: Select enable to enable SNMP feature
Contact: Enter the contact person or contact information for your access point.
Location: Enter an assigned location for your access point.
Community Name (Read only): Enter an assigned name for your access point.
Community (Read/Write): Enter a public and private community name.
Trap Destination Address: Enter the destination IP address of the SNMP trap.
Trap Destination Community Name: Enter the name of the destination community
SNMPv3: Select option to enable or disable SNMPv3
Username: Enter the username
Auth Protocol: Select from the pull down menu the authentication protocol to use
Authentication Key: Enter the authentication key
Priv Protocol: Select the private protocol
Priv Key: Enter the private key
Engine ID: Enter the engine name
© Copyright 2015 TRENDnet. All Rights Reserved.
Enable CLI
Management > CLI Settings
To enable the Command Line Interface for batch management or advanced
configuration, select CLI ON and then click Apply.
1. Log into your management page (see
2. Click on the Management tab and click CLI.
3. Select ON and click Apply to save settings.
LED Controls
Management > LED Control
1. Log into your management page (see
2. Click on the Management tab and click LED Control.
3. Review the settings and click Apply to save settings.
Power LED: Select On to leave Power LED on or Off option to turn off.
LAN LED: Select On to leave LAN LED on or Off option to turn off.
2.4GHz LED: Select On to leave wireless 2.4GHz LED on or Off option to turn off.
TEW-755AP
"Access the management
page" on page 16).
"Access the management
page" on page 16).
29