Groen OM-TDB/7 Operator's Manual

Groen OM-TDB/7 Operator's Manual

Steam jacketed kettle

Advertisement

IMPORTANT INFORMATION
IMPORTANT INFORMATION
IMPORTANT INFORMATION
IMPORTANT INFORMATION2
OPERATOR MANUAL
Part Number 121002
MODEL:
TDB/7
Steam Jacketed Kettle
Self-Contained
Electrically heated
Table top mounted
Tilting
THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE. READ,
UNDERSTAND AND FOLLOW THE INSTRUCTIONS AND WARNINGS
CONTAINED IN THIS MANUAL.
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS
AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
2KEEP FOR OPERATOR
KEEP FOR OPERATOR2
KEEP FOR OPERATOR
KEEP FOR OPERATOR
2
2
FOR YOUR SAFETY
2IMPORTANT INFORMATION
IMPORTANT INFORMATION
IMPORTANT INFORMATION
IMPORTANT INFORMATION
2
2
OM-TDB/7
DOMESTIC

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OM-TDB/7 and is the answer not in the manual?

Questions and answers

Summary of Contents for Groen OM-TDB/7

  • Page 1 IMPORTANT INFORMATION2 2KEEP FOR OPERATOR KEEP FOR OPERATOR KEEP FOR OPERATOR KEEP FOR OPERATOR2 2IMPORTANT INFORMATION IMPORTANT INFORMATION IMPORTANT INFORMATION IMPORTANT INFORMATION OM-TDB/7 OPERATOR MANUAL Part Number 121002 DOMESTIC MODEL: TDB/7 Steam Jacketed Kettle Self-Contained Electrically heated Table top mounted Tilting THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE.
  • Page 2: Important Operator Warnings

    OM-TDB/7 IMPORTANT — READ FIRST — IMPORTANT CAUTION: BE SURE ALL OPERATORS READ, UNDERSTAND AND FOLLOW THE OPERATING INSTRUCTIONS, CAUTIONS, AND SAFETY INSTRUCTIONS CONTAINED IN THIS MANUAL. WARNING: THIS UNIT IS INTENDED FOR USE IN THE COMMERCIAL HEATING, COOKING AND HOLDING OF WATER AND FOOD PRODUCTS, PER THE INSTRUCTIONS CONTAINED IN THIS MANUAL.
  • Page 3 FOLLOW THE DIRECTIONS ON THE LABEL OF THE CLEANER TO BE USED. CAUTION: USE OF ANY REPLACEMENT PARTS OTHER THAN THOSE SUPPLIED BY GROEN OR THEIR AUTHORIZED DISTRIBUTORS CAN CAUSE OPERATOR INJURY AND DAMAGE TO THE EQUIPMENT, AND WILL VOID ALL WARRANTIES.
  • Page 4: Table Of Contents

    OM-TDB/7 Table of Contents IMPORTANT OPERATOR WARNINGS ..............2 EQUIPMENT DESCRIPTION .
  • Page 5: Equipment Description

    OM-TDB/7 Equipment Description The Groen TDB/7 is a table top, tilting, steam A built-in steam generator, sized for the kettle jacketed kettle with a thermostatically controlled, capacity and heated by electricity, delivers steam self-contained, electrically-heated steam supply and into the jacket. “Airless” operation of the steam appropriate controls, mounted on a sturdy base.
  • Page 6 OM-TDB/7 New/Current Models Pre- Feb. 1995 Models Optional equipment available with any model: 1. Stand that supports the unit and holds a pan in position for filling 2. Lift-off cover 3. Basket insert 4. Fill faucet 5. Manual stirrers 6. Motor driven agitator...
  • Page 7: Inspection & Unpacking

    OM-TDB/7 Inspection & Unpacking The unit will arrive in a heavy shipping carton and will Write down the model number, serial number, and be attached to a skid. Immediately upon receipt, installation date, and retain this information for future inspect the carton carefully for exterior damage.
  • Page 8: Installation

    4. Bringing the electrical service through the panel. Any mechanical or electrical changes must be entrance at the rear of the support housing, approved in by Groen’s Food Service Engineering making a watertight connection with the Department. incoming lines. (A BX connection is not recommended.)
  • Page 9: Initial Start-Up

    5. To shut down the unit, turn the thermostat for use. If the unit does not function as intended, dial to “OFF”. contact your local Groen Certified Service Agency. A simple turn of the thermostat controls the Groen TBD/7 Kettle...
  • Page 10: Operation

    OM-TDB/7 Operation (old models). If the level is too low, see “Jacket Filling and Water Treatment” on page 10 of this manual. 2. Check the pressure gauge. If the gauge does not show 20 to 30 inches of vacuum (that is, a reading of 20 to 30 below 0), see “Jacket Vacuum”...
  • Page 11 OM-TDB/7 WARNING WHEN TILTING KETTLE PRODUCT TRANSFER: WEAR PROTECTIVE OVEN MITT AND PROTECTIVE APRON. 2) USE DEEP CONTAINER TO CONTAIN AND MINIMIZE PRODUCT SPLASHING. WARNING 3) PLACE CONTAINER ON STABLE, FLAT AVOID ALL DIRECT CONTACT WITH HOT SURFACE, AS CLOSE TO KETTLE AS SURFACES.
  • Page 12: Sequence Of Operation

    OM-TDB/7 2. Basket Insert AVOID ALL DIRECT CONTACT WITH HOT An optional kettle basket insert can assist in FOOD WAT ER IN THE KETTLE. cooking water-boiled products including DIRECT CONTACT COULD RESULT eggs, potatoes, vegetables, shell fish, pasta SEVERE BURNS.
  • Page 13: Maintenance

    OM-TDB/7 Maintenance NOTICE: Contact Groen or an authorized Groen representative when repairs are required. 1. Periodic Maintenance month. Test the valve with the kettle A Maintenance & Service Log is provided at operating at 15 psi (105 kPa), by holding the test lever for at least 5 seconds.
  • Page 14 OM-TDB/7 lever or ring for about 1 second. Repeat b. Tilt kettle 90° to a full pour position. Remove fill plug with open-end wrench or this step, then let the pull ring or valve crescent wrench. lever snap back into the closed position.
  • Page 15 OM-TDB/7...
  • Page 16 OM-TDB/7 4. Water Treatment Procedure Model Kettle Jacket Capacity Capacity TDB/7-20 20 quarts 4 quarts WARNING TDB/7-40 40 quarts 5 quarts TO AVOID INJURY, READ AND FOLLOW PRECAUT IONS STATED ON THE 5. Component Replacement LABEL WAT ER T REATMENT COMPOUND.
  • Page 17: Cleaning

    OM-TDB/7 Cleaning 1. Suggested Tools: Prepare a hot solution of the detergent/ Cleaner, such as Klenzade HC-10 or HC- cleaning compound as instructed by the 32 from ECOLAB, Inc. supplier. Clean the unit thoroughly. A cloth moistened with cleaning solution b.
  • Page 18 The outside of the unit may be polished Groen Delimer/Descaler (Part Number with a stainless steel cleaner such as 114800) or Lime-Away from Ecolab, in “Zepper” from Zep Manufacturing Co.
  • Page 19: Troubleshooting

    OM-TDB/7 Troubleshooting Your Groen kettle is designed to operate smoothly and efficiently if properly maintained. However, the following is a list of checks to make in the event of a problem. Wiring diagrams are furnished inside the service panel. If an item on the list is followed by X, the work should be done by a qualified service representative.
  • Page 20: Units Manufactured Before Sept. 1, 1988

    OM-TDB/7 l. Parts List (For units manufactured before September 1, 1988) * To order parts, contact your Groen Certified Service Agency. Supply the model designation, part description, part number, quantity, and, where applicable, voltage and phase. Description Part No. Description Part No.
  • Page 21 OM-TDB/7 (For units manufactured before September 1, 1998)
  • Page 22: Parts Lists

    OM-TDB/7 Parts List (For units manufactured between September 1, 1988 and July 1, 1992)* To order parts, contact your Groen Certified Service Agency. Supply the model designation, part description, part number, quantity, and, where applicable, voltage and phase. Description Part No.
  • Page 23 OM-TDB/7 (For units manufactured between September 1, 1988 and July 1, 1992)
  • Page 24: Units Manufactured Between July 1, 1992 And Feb. 6, 1995

    OM-TDB/7 Parts List (For units manufactured between July 1, 1992 and Feb. 6, 1995) * To order parts, contact your Groen Certified Service Agency. Supply the model designation, part description, part number, quantity, and, where applicable, voltage and phase. Description Part No.
  • Page 25 OM-TDB/7 (For units manufactured between July 1, 1992 and February 6, 1995)*...
  • Page 26: Units Manufactured After Feb. 6, 1995

    OM-TDB/7 Replacement Kettle Body Parts List (For units manufactured after Feb. 6, 1995) * * Date of manufacture stamped on National Board data plate.
  • Page 27 OM-TDB/7 Replacement Mechanical Parts List (For units manufactured after Feb. 6, 1995) * * Date of manufacture stamped on National Board data plate.
  • Page 28 OM-TDB/7 Replacement Electrical Parts List (For units manufactured after Feb. 6, 1995) * Date of manufacture stamped on National Board data plate.
  • Page 29 OM-TDB/7 Parts List (For units manufactured after Feb. 6, 1995) * To order parts, contact your Groen Certified Service Agency. Supply the model designation, part description, part number, quantity, and, where applicable, voltage and phase. Description Part No. Description Part No.
  • Page 30: Units Manufactured Before Sept. 1, 1988

    OM-TDB/7 Wiring Diagrams For units manufactured before September 1, 1988...
  • Page 31 OM-TDB/7 Wiring Diagrams For units manufactured before September 1, 1988...
  • Page 32 OM-TDB/7 Wiring Diagrams For units manufactured before September 1, 1988...
  • Page 33: Before June 1, 1990

    OM-TDB/7 Wiring Diagrams For units manufactured after September 1, 1988 and before June 1, 1990...
  • Page 34 OM-TDB/7 Wiring Diagrams For units manufactured after September 1, 1988 and before June 1, 1990...
  • Page 35 OM-TDB/7 Wiring Diagrams For units manufactured after September 1, 1988 and before June 1, 1990...
  • Page 36: Before July 1, 1992

    OM-TDB/7 Wiring Diagrams For units manufactured after June 1, 1990 and before July 1, 1992...
  • Page 37: Before Feb. 6, 1995

    OM-TDB/7 Wiring Diagrams For units manufactured after June 1, 1990 and before February 6, 1995...
  • Page 38: Before Feb. 6, 1995

    OM-TDB/7 Wiring Diagrams For units manufactured after July 1, 1992 and before February 6, 1995...
  • Page 39: Units Manufactured After Feb. 6, 1995

    Wiring Diagrams For units manufactured after Feb. 6, 1995 TDB/7-20, TDB/7-40 208/240 Volt, 1 and 3 Phase...
  • Page 40 Wiring Diagrams For units manufactured after Feb. 6, 1995 TDB/7-20, TDB/7-40 230 Volt 1 Phase and 400 Volt 3 Phase (International Units)
  • Page 41 Wiring Diagrams For units manufactured after Feb. 6, 1995 TDB/7-20, TDB/7-40 480 VOLT, 1 & 3 PHASE...
  • Page 42: Service Log

    OM-TDB/7 Service Log Model No. _______________________________ Purchased From _________________________ Serial No. _______________________________ Location ________________________________ Date Purchased __________________________ Date Installed ___________________________ Purchase Order No. ______________________ For Service Call __________________________ Date Service Performed Performed By References KLENZADE SALES CENTER ECOLAB. Inc. NATIONAL SANITATION FOUNDATION 370 Wabasha 3475 Plymouth Rd.
  • Page 43: Warranty

    Groen Equipment. This warranty does not cover defects caused by improper installation, abuse, careless operation, or improper maintenance of equipment.
  • Page 44 OM-TDB/7 (Revised 12/97) 1055 Mendell David Drive Jackson, MS 39212 Part Number 121002 Telephone 601 372-3903 Fax 601 373-9587...

Table of Contents