Camera Led; Power Connector - Dalsa PC-30-02K80 User Manual

Piranha Color Camera User's Manual
Note: Refer to the following sections for details on equipment recommendations and
camera connector information.

2.3 Camera LED

The camera is equipped with a red/green LED used to display the operational status of
the camera. The table below summarizes the operating states of the camera and the
corresponding LED states.
When more than one condition is active, the LED indicates the condition with the
highest priority. The fatal error state is accompanied by corresponding messages further
describing the problem.
Table 3: Diagnostic LED
Priority
1
2
3

2.4 Power Connector

Figure 2: Hirose 6-pin Circular Male—Power Connector
Hirose 6-pin Circular Male
1
2
3
Mat ing Par t: HIRO SE
HR10A -7P-6S
The camera requires a single voltage input (+12 to +15V). The camera meets all
performance specifications using standard switching power supplies, although well-
regulated linear supplies provide optimum performance.
WARNING: When setting up the camera's power supplies follow these guidelines:
!
Ensure +12V to +15V at the camera power input (after the voltage drop across the
power cable. This may mean that the power supply will have to provide a voltage
DALSA
Camera Link Connector
Camera Link Connector
Power Connector
Color of Status LED
Flashing Red
Flashing Green
Solid Green
6
Pin
5
1
4
2
3
03-032-10211-01
Meaning
Fatal Error. For example, camera temperature is too
high and camera thermal shutdown has occurred.
Camera initialization or executing a long command
(e.g., flat field correction commands ccp or ccf).
During this state, any other sent command is ignored.
Camera is operational and functioning correctly and
ready to receive commands.
Table 4: Hirose Pin Description
Description
Min +12 to Max +15V
Min +12 to Max +15V
Min +12 to Max +15V
16
Pin Description
4 GND
5 GND
6 GND
5/9/2007