Dalsa PC-30-02K80 User Manual page 84

Piranha Color Camera User's Manual
Mnemonic
set fpn coeff
set fpn range
set input LUT
set lower threshold
set mirroring mode
set output throughput
set prnu coeff
set prnu range
set readout mode
set spatial alignment
set subtract background
DALSA
Syntax Parameters
sfc x i
sfr x x i
sil t a i
slt i
smm i
sot m
spc x i
spr i1 i2 x
srm i
ssa i
ssb t i
03-032-10211-01
Description
allowable range.
Set the FPN coefficient. First must
select a single color with SCL.
x =pixel number within the range 1 to
n. Where n = 2048 or 4096.
i= FPN value within the range 0 to
4095 (12-bit LSB).
Set a range of pixel FPN coefficients.
First must select a single color with
SCL.
x1=first pixel number of the range.
x2=last pixel number of the range
i=coefficient value in a range from 0
to 4095.
Set a single value in a LUT. First must
select a single color with SCL.
t = Tap; 1 to 4 depending on color
a = Address within LUT; 0 to 1023
i = Value; -256 to 255
The pixels below the lower threshold
are counted and reported in the end-
of-line sequence.
i = Threshold in a range from 0-
4095.
Set mirroring mode:
0 = Left to right
1 = Right to left
Sets the camera's total throughput per
color. Valid values are: 30, 40, 60, or
80 mega-pixels per second per color.
Set a PRNU coefficient. First must
select a single color with SCL.
x=pixel number within the range 1 to
n. Where n = 2048 or 4096.
i= PRNU value within the range 0 to
61438.
Set a range of pixel PRNU coefficients.
First must select a single color with
SCL.
i1 = first pixel number of the range
i2 = last pixel number of the range
x = coefficient value in a range from 0
to 61438.
Select vertical transfer dark clear mode.
0 = Auto, clears dark below
approximately 60% of maximum line
rate
1 = Always clears dark; reduces the
maximum line rate
2 = Off
Set line delay between colors. 0 to 6.
Subtract this value from the output
signal.
84
5/9/2007