Dalsa PC-30-02K80 User Manual page 82

Piranha Color Camera User's Manual
Mnemonic
get line average
get prnu coeff
get signal frequency
help
load FPN coefficients
load factory settings
load input LUT
load pixel coefficients
load user settings
reset camera
reset input LUT
region of interest
reset pixel coeffs
set add background
set analog gain
DALSA
Syntax Parameters
gla x1 x2
gpc x
gsf i
h
lfc
lfs
lil
lpc
lus
rc
ril
roi x1 x2
rpc
sab ti
sag t f
03-032-10211-01
Description
Read the average of line samples.
x1 = Pixel start number
x2 = Pixel end number
in a range from 1 to n. Where n =
2048 or 4096.
Displays a PRNU coefficient.
x = pixel number to read in a range
from 1 to n. Where n = 2048 or 4096.
Reads the requested Camera Link
control frequency.
1 = EXSYNC frequency
2 = CC2
3 = Direction
4 = CC4
Display the online help.
Loads the FPN coefficients from non-
volatile memory to current. This
command is modified by the ssn
command.
Loads the camera's factory settings
LUT, FPN and PRNU coefficients.
Also used to clear a fatal error if the
user settings are corrupt at power up.
Load input LUT's from non-volatile
memory to current. Modified by the
ssn command.
Load the previously saved PRNU
coefficients from non-volatile memory.
Modified by the ssn command.
Load the camera user settings from
non-volatile memory. Modified by the
ssn command.
Resets the entire camera (reboot).
Baud rate is not reset and reboots with
the value last used.
Set all values in all current LUT's to
zero.
Sets the pixel range affected by the
ccg, gl, gla, cil, ccf, ccp,
and cpa commands. The parameters
are the pixel start and end values (x).
Resets the FPN and PRNU
coefficients to 0.
Set 12 bit value to add at end of digital
chain.
t = Tap; 0 to 4 depending on color
selected; 0 for all taps
i = Value to add
Sets the analog gain in dB.
t = tap selection, either 1 or 4
depending on the color selected, or 0
for all taps.
f= gain value specified from –10 to
82
5/9/2007