A5 Error Handling - Dalsa PC-30-02K80 User Manual

Piranha Color Camera User's Manual
Mnemonic
write user settings

A5 Error Handling

The following table lists warning and error messages and provides a description and
possible cause. Warning messages are returned when the camera cannot meet the full
value of the request; error messages are returned when the camera is unable to complete
the request.
Table 10: Warning and Error Messages
Message
Warning 01:
Outside of
specification>
Warning 02:
Clipped to min>
Warning 03:
Clipped to max>
Warning 04: Related
parameters
adjusted>
Warning 07:
Coefficient may be
inaccurate A/D
clipping has
occurred>
Warning 08: Greater
than 1% of
coefficients have
been clipped>
Warning 09:
Internal line rate
inconsistent with
read out time>
Error Message
Error 01: Internal
error xx>
Error 02:
Unrecognized
command>
Error 03: Incorrect
number of
parameters>
DALSA
Syntax Parameters
wus
Description
Parameter accepted was outside of specified operating range (e.g. gain
greater than ±10 dB of factory setting, or SSF below specification).
Parameter was clipped to the current operating range. Use GCP or
GET to see value used.
Parameter was clipped to the current operating range. Use GCP or
GET to see value used.
Internal operating condition is adjusted to accommodate the entered
command. E.g. requesting exposure time longer than line time
automatically adjusts the line time to meet the exposure time
requirement.
In the region of interest (ROI) greater than 6.251% single or 1% of
averaged pixel values were zero or saturated.
Greater than 1% of FPN or PRNU coefficients have been calculated to
be greater than the maximum allowable and so were clipped.
Changes to the parameter (e.g. horizontal averaging) have changed read
out time and that is greater than the internal SYNC.
Description
Where xx is a code list below.
Only output during power up.
Customer should contact Dalsa customer support.
Command is not valid (or not available at the current access level).
Too many or too few parameters.
03-032-10211-01
Description
non-volatile memory set previously
using the ssn command.
Write current camera settings to non-
volatile memory set previously using
the ssn command.
86
5/9/2007