Installing, Connecting, Detecting, And Saving; Installing Quickcam And Camera Drivers; Installing Drivers For Your Camera - Dalsa QuickCam User Manual

7
Installing, Connecting,
Detecting, and Saving

2.1 Installing QuickCam and Camera Drivers

To install QuickCam:
1. Insert the camera CD into your CD-ROM drive.
2. Click Install QuickCam and follow the online instructions to complete the

Installing Drivers for Your Camera

Before installing drivers, ensure that your PC is equipped with a GigE network
interface (also referred to as a network adapter) based on Intel's 82540 chip.
Many motherboard manufacturers are designing this chip directly into their
board in "LAN on the motherboard (LOM)" implementations. Alternately, an
Intel 82540-based network adapter, also known as a network interface card, can
be slotted into a PC.
To install Spyder3 GigE drivers:
1.
03-032-10187-04
If the installation wizard does not start automatically, click Start on the
Windows taskbar, and click Run. Type D:\Setup, where D is the letter that
corresponds to your CD drive.
installation.
If you are using a Spyder3 GigE camera, you must install drivers before
running QuickCam.
Open the Driver Installation Tool. On the Windows task bar click Start,
point to Programs DALSA QuickCam
Installation Tool.
If you are using an Intel PRO/1000 adapter:
a)
On the Pro 1000 Adapters tab, right click on an Intel PRO/1000
network interface card adapter with no installed driver (i.e. when
the Device Class is Ethernet Controller).
The following context menu appears:
2
Tools Launch Driver
QuickCam User's Manul
DALSA corp.