The Effects Of The Processing Chain On Calibration - Dalsa PC-30-02K80 User Manual

Piranha Color Camera User's Manual
The digital offset (
offset (the analog offset) so that application of the PRNU coefficient doesn't result
in artifacts at low light levels due to the offset value. You may want to set the
value if you are not using FPN correction but want to perform PRNU correction.
Photo-Response Non-Uniformity (PRNU) coefficients (calculated using the
cpa
pixels (i.e. given the same amount of light different pixels will charge up at different
rates) and the difference in light intensity across the image either because of the
light source or due to optical aberrations (e.g. there may be more light in the center
of the image). PRNU coefficients are multipliers and are defined to be of a value
greater than or equal to 1. This ensures that all pixels will saturate together.
Background subtract (
used to increase image contrast after FPN and PRNU calibration. It is useful for
systems that process 8-bit data but want to take advantage of the camera's 12 bit
digital processing chain. For example, if you find that your image is consistently
between 128 and 255DN(8 bit), you can subtract off 128 (
multiply by 2 (
Background addition (sab command) is used to ensure a minimum output value,
and is added to the digital video after the system gain is applied.

The Effects of the Processing Chain on Calibration

The Processing Chain (as shown in Figure 7):
Video out = (([video in] x SAG + SAO - SDO - FPN) x PRNU – SSB) x SSG +
SSB
Calibration takes place at the output of the parameter being calibrated. If the parameters
further down the chain are not zero or unity, then the video out may not be as expected.
For example, if the analog gain is calibrated to an average of 3,000 DN using "CCG 2 0
3000" while SSB is 100, the average video output will be 2,900 DN not 3,000 DN.
This applies to:
CCG: calibrate analog gain (SAG) or system gain (SSG)
CCF: calibrate FPN
CCP: calibrate PRNU
CPA: calibrate analog gain (SAG) and PRNU
PRNU calibration includes the FPN whether it is enabled or not (as they are linked). If
you do not want the PRNU calibration to include the effect of FPN then it should be
zeroed first using the RPC command.
CCG 3 (system gain) only includes FPN and PRNU if they are enabled with EPC.
Note: Refer to section 3.8 Set Color Correction
Purpose:
Syntax:
Syntax Elements:
DALSA
command) enables the subtraction of the "artificial" A/D
sdo
commands) are used to correct the difference in responsivity of individual
command) and system (digital) gain (
ssb
) to get an output range from 0 to 255.
ssg 0 8192
Sets the color correction coefficients.
scc Co C1 C2 C3
Co = offset (0 to 4095)
C1 = red multiplier (-8192 to +8191)
C2 = green multiplier (-8192 to +8191)
C3 = blue multiplier (-8192 to +8191)
03-032-10211-01
sdo
or
ccp
command) are
ssg
) and then
ssb 2048
38
5/9/2007