Dalsa PC-30-02K80 User Manual page 83

Piranha Color Camera User's Manual
Mnemonic
set analog offset
set averaging horizontal
set baud rate
select cable
set color correction
set ccd direction
set color
set digital offset
set exposure mode
set exposure time
DALSA
Syntax Parameters
sao t i
sah i
sbr i
scb i
scc i1 i2 i3 i4
scd i
scl s
sdo t i
sem m
set f
03-032-10211-01
Description
+10 dB
Sets the analog offset.
t = tap selection, 1 to 4 depending on
color selected, or 0 for all taps.
i= Offset value in a range from 0 to
255 (12-bit LSB). Set to three time
RMS noise at high gain.
Sets the number of horizontal pixels to
average. Available values are 1 (factory
settings) and 2.
Set the speed of camera serial
communication port. Baud rates:
9600, 19200, 57600, and
115200. Power on default: 9600.
Sets the cable parameter. Increase this
value for longer cables and decrease
the value for shorter cables.
Set how three video streams from the
CCD are combined to provide the four
(red, green, blue, and luminance)
output streams. Use SCL to select the
color, RGB for luminance, to modify.
i1 = Offset (0 to 4095)
i2 = Red multiplier (-8192 to 8191)
i3 = Green multiplier (-8192 to 8191)
i4 = Blue multiplier (-8192 to 8191)
Multipliers are divided by 4096 to get
the actual factor.
Sets the CCD shift direction where:
0 = Forward CCD shift direction.
1 = Reverse CCD shift direction.
2 = Externally controlled direction
control via CC3.
rgb/r/g/b
Subtracts this value from the video
signal prior to FPN correction.
t = tap selection, 1 to 4 depending on
color selected, or 0 for all taps.
i = Offset in a range from 0 to 4095.
Sets the exposure mode:
2 = Internal line rate and exposure
time set using commands ssf and
set
3 = External SYNC, maximum
exposure time
4 = Smart EXSYNC
5 = External SYNC and PRIN
6 = External SYNC, internal exposure
time set using SET command
7 = Internal line rate, maximum
exposure time. Factory setting.
Sets the exposure time. Refer to the
camera help screen (h command) for
83
5/9/2007