Gold Note VALORE Plus 425 Owner's Manual page 11

VTA SETUP
CYLNDER EYE
Insert the supplied anti-skate weight
(3)[see previous page] into the
anti-skate Nylon then pass the Nylon
Wire through the micro hole of the
Cylinder Eye indicated here with the
red arrow. Make a not to block the
wire and lay it of the outer groove as
shown below
OWNER'S MANUAL
VTA SETUP
Loose the indicated Hex-bolt of the arm
collar with the 1,5mm Allen Wrench sup-
plied in the tone-arm accessories, to lift
and down the arm correctly adjusting the
VTA as necessary.
AZIMUTH
After the cartridge is properly installed on the tone
arm adjust the Azimuth of the shell with the supplied
0,9mm Allen Wrench supplied.
The correct Azimuth enhances high quality audio
performance.
HINGES FRICTION ADJUSTMENT
The Hinges friction maybe adjusted to let the Dust Cover keeps
open inclined front or even backward.
Turn the Philips screw clockwise to increase the friction, the
opposite, anti-clockwise to decrease the friction and the hinge
resistance.
up
page 10