Removing A Fuse; Installing The Fuse; Removing The Seat - KTM 530 EXC Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing a fuse

9.78

Installing the fuse

9.79
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect fuses.
–
Use only fuses with the prescribed amperage. Never by-pass or repair fuses.

Removing the seat

9.80
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the generator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove the lid
Charge the battery with at most 10% of the capacity specified on the bat-
400240-10
tery
–
Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use.
–
Mount the seat. (
–
Switch off all power-consuming components and switch off the engine.
–
Dismount the air filter box lid. (
–
Remove the protection cover
Info
The fuse
–
Remove the fuse
400270-10
–
Insert the fuse.
Fuse (58011109110)
Info
A reserve fuse
Replace a burned-out fuse
If the new fuse burns out, contact an authorized KTM workshop.
–
Replace the protection cover.
400273-10
–
Install the air filter box lid. (
–
Remove screw
above.
500080-10
.

.

p. 66)
p. 70)
.

is located in the starter relay

.

is located in the starter relay.

only by an equivalent fuse.

p. 70)
. Lift up the seat at the rear, pull it back and then remove from

3 months
under the filter box cover.

65