Removing A Fuse; Replacing The Fuse - KTM 450 SXS-F Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE

Removing a fuse

Replacing the fuse

Warning
Fire hazard The electrical system can be overloaded by the use of incorrect fuses.
Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the generator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove the lid
Charge the battery according to the instructions
Switch off the charger after charging. Disconnect the battery.
Specification
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use.
Mount the seat. (
200396-10
Switch off all power-consuming components and switch off the engine.
Dismount the air filter box lid. (
Remove the protection cover
Info
The fuse
Remove the fuse
400270-10
Check parts for damage and wear. Replace damaged or worn parts.
Info
A reserve fuse
Replace a burned-out fuse
Refit the fuse.
Fuse (58011109110) (
Info
400273-10
If the new fuse burns out, contact an authorized KTM workshop.
Replace the protection cover.
Install the air filter box lid. (
.
3 months
P. 55)
P. 60)
.
is located in the starter relay
.
is located in the starter relay.
only by an equivalent fuse.
P. 76)
P. 61)
on the battery casing.
under the filter box cover.
54