Hardware Installation; Interface Cable Connection; 1Sae Module Cable Connection - SignaMax 065-1530 Install Manual

Hardware Installation

Step 1: Complete machine installation and ensure that the power supply
switch is off.
Step 2: Connect one side of AC power supply cable to entry side of
router power supply and other side to power supply jack.
Step 3: Configure the router via console port after first power on.
Step 4: Insert one side of configuration cable to console port and other
side to PC or terminal serial.
Step 5: Insert one side of Ethernet cable to LAN interface and other side
to LAN.
Step 6: Connect sync/async communication cable to router WAN
interface.
The 065-1530 Signamax Security Router sync/async interface works
in the mode of V.24 or V.35. The two modes are completed via
V.24/V.35 button. In V.24 mode, interface adopts standard RS232
cable connection.
In V.35 mode, interface adopts special V.35DTE cable connection.
V.35DTE cable:
Step 7: After completing the cable connection, open the power supply
switch for router configuration.

Interface Cable Connection

1SAE Module Cable Connection

This section explains 1SAE module and cable connection.
NOTE: Before connecting sync/async serial, ensure the following:
30 SIGNAMAX LLC • www.signamax.eu