• Ethernet is a trademark of Xerox Corporation. • Microsoft Windows is a trademark of Microsoft Corporation. • Signamax is a trademark of Advanced Electronic Support Products, Inc. User’s Manual...
Signamax Hardened PoE Ethernet Switch Quick Start Guide This quick start guide describes how to install and use the Hardened PoE Ethernet Switch. This is the switch of choice for harsh environments. Functional Description • Meets NEMA TS1 & TS2 Environmental requirements: temperature, shock, and vibration for traffic control equipment.
Page 5
Signamax Hardened PoE Ethernt Switch State Indication Steady Power on. Power1 Power2 Power off. Steady Power redundant system failure occurred. Fault Power redundant system failure is not occurred. 10/100BaseTX Steady A valid network connection established. Link/ACT Transmitting or receiving data.
Page 6
Signamax Hardened PoE Ethernet Switch Signal Name Signal Definition Output Transmit Data + TD+ Output Transmit Data - TD- Input Receive Data + RD+ Positive (VCC+) Positive (VCC+) Input Receive Data - RD- Negative (VCC-) Negative (VCC-) 2. The 1000BaseT Connections The following lists the pinouts of 1000BaseT ports.
Page 7
Signamax Hardened PoE Ethernt Switch 4. The 1000BaseSX/LX Connections The fiber port pinouts: The Tx (transmit) port of device I is connected to the Rx (receive) port of device II, and the Rx (receive) port of device I to the Tx (transmit) port of device II.
Signamax Hardened PoE Ethernet Switch Preface This manual describes how to install and use the Signamax Hardened PoE Ethernet Switch. A member of the growing family of rugged switches, this Hardened PoE Ethernet Switch provides an affordable solution for rugged and...
Signamax Hardened PoE Ethernet Switch Product Overview Hardened PoE Ethernet Switch Package Contents When you unpack this product package, you will find the items listed below. Please inspect the contents, and report any apparent damage or missing items immediately to our authorized reseller.
Signamax Hardened PoE Ethernt Switch Front Panel Display Status LEDs State Indication Steady Power on. Power1 Power2 Power off. Steady Power redundant system failure occurred. Fault Power redundant system failure is not occurred. 10/100BaseTX Steady A valid network connection established.
Signamax Hardened PoE Ethernet Switch Physical Ports This switch series provides different combinations of RJ-45 copper and fiber ports as below: • 16 x 10/100BaseTX PoE ports + 2 x Gigabit Ethernet ports • 12 x 10/100BaseTX PoE ports + 2 x Gigabit Ethernet ports •...
Signamax Hardened PoE Ethernt Switch Installation This chapter gives step-by-step installation instructions about how to install the Switch. Selecting a Site for the Equipment As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference.
Signamax Hardened PoE Ethernet Switch There are two pins on the terminal block are used for power failure detection. Use this as a dry contact application to send a signal for power failure detection. Power Input Assignment + 47-57VDC Power2 -...
Page 15
Signamax Hardened PoE Ethernt Switch Cabling Step 1: First, ensure the power of the switch and end devices are turned off. <Note> Always ensure that the power is off before any installation. Step 2: Prepare cable with corresponding connectors for each type of port in use.