Grounding Wire Connection; Module Installation; Rack/Desk; Panel Wire Connection - SignaMax 065-1530 Install Manual

Grounding Wire Connection

The 065-1530 Signamax Security Router grounding wire normal
connection ensures protection against thunder and anti-jamming.
Configure the power supply yawp filter at the input end of router
power supply. Connect the center with chassis. For external network
connection, such as E1 interface, the grounding cable protects PSTN.
Connect this point and ground using a thick cable with the
resistance not more than 4
standard rack, ground the rack well.

Module Installation

065-1530 Signamax Security Router adopts modular system
structure and different kinds of interface configuration. Following are
the module installation steps:
Step 1: Choose the module and interface (relation of module and slot
refers to basic configuration and module configuration list).
Step 2: Insert module into slot. Insert the module circuit board into
interface card slot.
Step 3: Push in the module close to back panel
Step 4: Tighten the screw

Rack/Desk

If 065-1530 Signamax Security Router is placed onto 19-inch
standard rack, use front-end installation method. If 065-1530
Signamax Security Router is placed on desk, stick the formula.

Panel Wire Connection

Panel wire connection includes Ethernet interface cable, WAN
sync/async cable connection.
. If the router is installed on 19-inch
Ω
29 SIGNAMAX LLC • www.signamax.eu