Saving Measurements - Anritsu S412E User Manual

Quick Start Guide
3-8

Saving Measurements

The LMR Master can save files in the following formats based on measurement mode and
installed options:
filename.spa for SPA measurement
filename.mna for VNA and VVM measurements
filename.s2p S2P (SnP) for VNA S-parameter measurements
filename.hipm for High Accuracy Power Meter measurements
filename.pm for Power Meter measurements.
filename.cwsg for CWSG measurements.
filename.afp for AM/FM/PM measurements
filename.ia for Interference Analysis measurements
filename.cs for Channel Scanner measurements
filename.wmxd for WiMAX
filename.wmxe for Mobile WiMAX
filename.lte for LTE measurements
filename.nbfm for NBFM measurements
filename.p25 for P25 measurements
filename.p252 for P25p2 measurements
filename.nxdn for NXDN measurements
filename.dpmr for dPMR measurements
filename.dmr2 for DMR 2 measurements
filename.ptc for PTC measurements
filename.tetra for TETRA measurements
filename.jpg for JPEG images
filename.stp for Setup files
filename.lim for Limit lines
Note The LMR Master is not fully supported in Master Software Tools.
Procedure for Saving Files:
1. Press Shift then File (7).
2. Press Save.
3. Press Change Save Location and set the current location to be the USB flash drive or
internal memory, and then press Set Location.
4. Press Change Type (Setup/JPG/...) and select the desired file type from the Select File
Type list box and press Enter.
5. Enter the filename by using the keyboard and then press Enter.
Refer to Chapter 4, "File Management"
S412E UG
for additional details about working with files.
PN: 10580-00318 Rev. P
3-8 Saving Measurements
3-23