Adjusting The Angle Of Trailing Edge - Kyocera DP-750 Service Manual

(2) Adjusting the angle of trailing edge

Perform the following adjustment if the trailing edge of the copy image is laterally skewed.
Procedure
1. Place an original on the DP and press the
start key to make a test copy.
2. If the gap of trailing edge exceeds the refer-
ence value, perform the following adjust-
ment.
Reference value
For simplex copying: Within ±3.0 mm
For duplex copying: Within ±4.0 mm
3. Open the DP top cover.
4. Remove four screws and then remove the
DP rear cover.
5. Adjust the height of DP.
Loosen the nut.
For copy example 1: Loosen the adjusting
screw.
For copy example 2: Tighten the adjusting
screw.
Amount of change per scale: Approx. 0.5
mm
Retighten the nut.
6. Refit the DP rear cover.
Original Copy
example 1
Figure 1-5-21
Screw
DP rear cover
Figure 1-5-22
Adjusting screw
Figure 1-5-23
3 mm/4 mm 3 mm/4 mm
Copy
example 2
DP top cover
Screw
Screw
Screw
Nut
3LL/3LK
1-5-13