Set Datalog/Print(Configure); Set Datalog/Print (Select_List); Administrative Setup - Omega FC-21 User Manual

FC-21 Flow Computer
Sub-menus
6.4.22
SET DATALOG/PRINT
SETUP
DATALOG/PRINT
(Select_list)
SET DATALOG/PRINT
Config
PRINT LIST ITEMS
TOTAL
PRINT LIST ITEMS
STOP
START
RATE
List Items:
PRINT LIST ITEMS
TOTAL
PRE 1
RATE
PRE1
TEMP
GRAND
PRINT LIST ITEMS
PRE2
DataLog size =001489
DENS
TIME
6.4.23

ADMINISTRATIVE SETUP

ADMINISTRATIVE
SETUP
OPERATOR PASSWORD
SUPERVISOR PASSWORD
SOFTWARE VERSION
PRODUCT ORDER CODE
UNIT SERIAL NUMBER
SENSOR SERIAL NUMBER
Display
ENTER
Select_list
ENTER
ENTER
Advance To
ADMINISTRATIVE SETUP
ENTER
ENTER
ENTER
ENTER
FC-21xxxxxxx
ENTER
00000
ENTER
00000
ENTER
Advance To
SETUP NETWORK CARD
Press enter to begin Setup Datalog/Print
routine.
Press enter when Select_list is selected to
setup print list.
Use Up and Down arrow keys to view list
YES status.
Press the Corresponding function key to the
items that you wish to add or remove from the
YES
list.
Items marked with Yes will be added to the
list,
YES items marked with No will be removed from
the list.
The Select Print List Information display
shows the current possible Datalog size.
Press Enter to begin Administrative Setup.
Enter Operator Password. (Factory Set to 0)
*****
Enter Supervisor Password.
***** (Factory Set to 2000)
This display is used to show the software
vxx.xx version of the installed software.
This display is used to show the product order
code (model number).
This display is used to show the unit's serial
number.
This display is used to show the sensor's
serial number.
36
Notes