Set Fluid Properties; Setup Pulse Output - Omega FC-21 User Manual

Sub-menus
6.4.12

SET FLUID PROPERTIES

SET FLUID
PROPERTIES
REF. DENSITY
REF. TEMPERATURE
EXPAN. FACTOR [xe-6]
CALIBRATION DENSITY
VISCOSITY COEF. A
VISCOSITY COEF. B
BASE DENSITY H2O@4C
6.4.13

SETUP PULSE OUTPUT

SETUP
PULSE OUTPUT
PULSE OUTPUT USAGE
Off
PULSE WIDTH
10mS
PULSE VALUE
Display
ENTER
###### lbs/g
ENTER
######
ENTER
########
ENTER
########
ENTER
0.000
ENTER
0.000
ENTER
###### lbs/g
ENTER
Advance To
SETUP PULSE OUTPUT
ENTER
Vol CVol/Mass
ENTER
ENTER
####### gal/P
ENTER
Advance To
SETUP ANALOG OUTPUT
Press ENTER at this prompt to Set Fluid
Properties.
Enter the Reference Density. This is used in
the calculation of density when you have a
temp transmitter and used for corrected flow
calculation if you have a density transmitter.
Enter the Reference Temperature.
F
Enter the proper Expansion Factor.
(If Temp Compensated for Mass or Corrected
Volume) See Section 7.4, Calculating the
Expansion Factor.
Enter the Calibration Density. This is used in
calculation of flow for analog inputs using SQRT.
Enter the Viscosity A Coefficient. See section
7.5, Computation of Viscosity Coef. A and B.
Enter the Viscosity B Coefficient. See section
7.5, Computation of Viscosity Coef. A and B.
Enter the Base Density H2O@4C. This is
used in the centistoke calculation for UVC.
Press ENTER at this prompt to setup the
Pulse Output.
Select the desired Pulse Output Usage.
Select the desired Pulse Width for the Pulse
100mS Output.
Enter the desired Pulse Value for the Pulse
Output (Units per Pulse).
29
FC-21 Flow Computer
Notes