Omega FC-21 User Manual page 39

Sub-menus
6.4.20
CALL ON ERROR/ALARM
SERIAL USAGE
No
(continued)
NUMBER OF REDIALS
HANGUP IF 2MIN INACT
No
6.4.21
SETUP DATALOG/PRINT
SETUP
DATALOG/PRINT
(Configure)
SETUP DATALOG/PRINT
Config
OUTPUT FORMAT
Printer Term Dbase
PAGE LENGTH [66 max]
TOP MARGIN
DATALOG PRINT ONLY
No
PRINT TIME
PRINT INTERVAL
ENABLE PRINT KEY
NO
PRINT END OF BATCH
NO
Display
ENTER
ENTER
ENTER
Advance To
SETUP DATALOG/PRINT
ENTER
Select_list
ENTER
ENTER
ENTER
[60 max]
ENTER
ENTER
HH:MM:SS
00:00:00
ENTER
00:00:00
ENTER
ENTER
ENTER
Advance To
SETUP DATALOG/PRINT
(Select_list)
Select "Yes" to have the unit perform a Call
Out transmission upon error/alarm condition.
Yes
Enter the number of redials to be performed
on call out time if busy or no answer. (error/
0
alarm tries until connected)
Select "Yes" to perform hangup if there is
inactivity for more than 2 minutes.
Yes
Press Enter to setup the Datalog/Print
information.
Select Config to configure the Datalog/Print
information.
Select the type of Output Format.
Enter the desired Page Length.
If Printer selected above.
66
Enter the desired Top Margin.
If Printer selected above.
3
Select Yes to record events to the datalogger
only. Events will not be sent to the serial port.
Yes
Enter Print Time, printer will print at this time
every day. Enter 00:00:00 to inhibit print time.
Enter Print Interval,
Enter 00:00:00 to inhibit print interval..
Select YES to enable Print Key.
Select NO to disable Print Key
YES
Batch mode only.
Select Yes to print at end of batch.
YES
35
FC-21 Flow Computer
Notes