Table of Contents
Advertisement
Chapter 2 : Jumpers and Connectors
• If possible, wear a grounded wrist strap when you are working inside the
computer case. Alternatively, discharge any static electricity by touching
the bare metal chassis of the unit case, or the bare metal body of any
other grounded appliance.
• Hold electronic circuit boards by the edges only. Do not touch the
components on the board unless it is necessary to do so. Don't flex or
stress the circuit board.
• Leave all components inside the static-proof packaging that they shipped
with until they are ready for installation.
• Use correct screws and do not over tighten screws.
Copyright © 2012 NEXCOM International Co., Ltd. All rights reserved
7
EBC 354 User Manual
Advertisement
Table of Contents
