Advanced - TRENDnet WAP-200A User Manual

When configure as Static IP address mode, it defines the IP address of your device.
Default subnet mask
When configure as Static IP address mode, it defines the subnet mask specifies the network
number portion of an IP address.
Default gateway
When configure as Static IP address mode, it defines the IP address of the gateway that
connects you to the internet.
Security
User name
This is the user name that you must type when logging in to these web pages.
Administrator password
This is the password that you must type when logging in to these web pages. You must enter
same password into both boxes, for confirmation.

Advanced

On this section you can configure the advanced 802.11g wireless settings. If you have changed any
settings it is necessary to reboot the device for the new settings to take effect.
Fragmentation Threshold
This setting should remain at its default value of 2346. Setting the Fragmentation value too low
may result in poor performance.
RTS Threshold
This setting should remain at its default value of 2346. If you encounter inconsistent data flow,
only minor modifications to the value are recommended.
Beacon Period
Beacons are packets sent by a wireless AP to synchronize wireless devices. Specify a Beacon
Period value between 20 and 1000. The default value is set to 100 milliseconds.
DTIM Interval
A DTIM is a countdown informing clients of the next window for listening to broadcast and
multicast messages. When the wireless AP has buffered broadcast or multicast messages for
associated clients, it sends the next DTIM with a DTIM Interval value. Wireless clients detect
the beacons and awaken to receive the broadcast and multicast messages. The default value
is 1. Valid settings are between 1 and 255.
17