Headlamp Levelling Switch; Digital Clock - SSANGYONG MUSSO Owner's Manual

3–28 INSTRUMENTS AND CONTROLS

HEADLAMP LEVELLING SWITCH*

With the low beam switched on, adjust the
aiming angle of headlights to suit the vehicle
load.
• To lower the aiming angle, push the
switch downward.
• To raise the aiming angle, push the
switch upward.
NOTE
According to load condition, adjust
the aiming angle of headlights.

DIGITAL CLOCK

When the ignition is on, the time is displayed
in the digital clock.
There are three adjusting buttons for the digi-
tal clock.
1. H : Hour Adjusting Button
To go forward one hour, press H button
once using a pointer, such as ball-point
pen, with the ignition on.
To go forward continuously, keep this
button depressed.
2. M : Minute Adjusting Button
To go forward one minute, press MIN
button once using a pointer, such as ball-
point pen, with the ignition on.
To go forward continuously, keep this
button depressed.
3. S : Setting Button
To reset the time by the time signal, press
the SET button using a pointer, such as
ball-point pen, with the ignition on.
For example, if this button is pressed
while the time is between 8:00 and 8:29
the display is set to 8:00. If this button
is pressed while the time is between
8:30 and 8:59, the display is set to 9:00.
8:00 ~ 8:29 → 8:00
8:30 ~ 8:59 → 9:00
NOTE
When disconnecting the battery or
replacing the fuse, the clock should
be adjusted again.