SSANGYONG MUSSO Owner's Manual page 113

8. As the jack begins to raise the vehicle,
make sure jack is properly placed so it
will not slip.
NOTE
Do not raise vehicle more than is
necessary to change wheel.
WARNING
Never get under car or start or run
the engine while car is supported by
a jack.
Vehicle may slip off the jack
resulting in serious injury or death.
(Rear)
9. Remove wheel nuts completely by
turning counterclockwise.
10. Remove tyre and wheel.
11. Mount spare tyre on the wheel hub.
CAUTION
• Never use oil or grease on wheel
nuts.
• Always use the correct wheel nuts.
• Using the wheel nut wrench in the
vehicle tool kit, tighten the nut
down firmly.
• As soon as possible, take your car
to a Ssangyong
Ssangyong Authorized Service
Operation and have the wheel nuts
tightend according to Ssangyong
specifications.
• If tighten inconnectly, the nuts
could come loose.
12. Replace and lightly seat the wheel nuts
by turning clockwise.
13. Turn jack connection rod counter-
clockwise and lower vehicle to the
ground.
14. Tighten the wheel nuts firmly to 74±14
lb-ft (100±20N • m); for steel wheel, 89±7
lb-ft (120±10N • m); for aluminum wheel
according to sequence No. of below
figure.
15. Check and adjust tyre pressure.
16. Secure the jack and tools in their proper
locations.
17. Secure the flat tyre in the spare tyre well
dealer or
on the tailgate.
IN CASE OF EMERGENCY 6–7