3 Manual Installation
Installation
This chapter will help you to manually install your MediaAccess Gateway.
Setting up your network
Proceed as follows:
1 Connect your MediaAccess Gateway to your service provider's network.
For more information, see
2 Power on the MediaAccess Gateway.
For more information, see
3 Connect your computer to the MediaAccess Gateway.
For more information, see
4 Configure your MediaAccess Gateway.
For more information, see
5 Connect your phones.
For more information, see
6 Share your content or media on your local network, continue with
7 If you purchased the mobile USB adapter, setup the 3G backup connection.
For more information, see
8 Once you successfully installed your MediaAccess Gateway, it is recommend to backup your configuration. This will
allows you to return to this configuration when needed (for example, after misconfiguration). For more information, see
"4.2 Backing Up/Restoring your Configuration" on page
DMS-CTC-20120510-0000 v1.0
"3.1 Connecting the MediaAccess Gateway to your Service Provider's Network" on page
"3.2 Powering on the MediaAccess Gateway" on page
"3.3 Connecting Your Network Devices to the MediaAccess Gateway" on page
"3.4 Configure the MediaAccess Gateway" on page
"6 Telephony" on page
47.
"3.5 Setting Up the 3G Fall-Back WAN Connection" on page
37.
3 MANUAL INSTALLATION
22.
26.
"8 Sharing Content" on page
63.
27.
20.
23.
19