Technicolor MediaAccess TG788VN Setup And User Manual page 116

Telephone cable
CAUTION
!
To reduce the risk of fire, use only No 26 AWG wire size or larger telecommunication line cord.
Connect the telecommunication line cord only in the PSTN, FXO, DSL, ADSL, SHDSL, VDSL or Line port of the
product. Never plug the telecommunication line cord in another receptacle of the product.
Follow the installation instructions in the sequence as outlined in the installation guide.
Central splitter / distributed filter(s) (if applicable)
If telephone service is required on the same line, a central splitter or distributed filter(s) must be installed for optimal
DSL performance.
Depending on your DSL configuration and type of splitter / filters, installation must be carried out by qualified service
personnel. Consult your telephone service company or DSL service provider for instructions.
Accessibility
The Direct Plug-in power supply, or the plug on the power supply cord serves as disconnect device. Be sure that the
power socket outlet you plug the power supply into is easily accessible and located as close to the equipment as
possible.
Overloading
Do not overload mains supply socket outlets and extension cords as this increases the risk of fire or electric shock.
Servicing
To reduce the risk of electric shock, do not disassemble this product. None of its internal parts are user-replaceable;
therefore, there is no reason to access the interior. Opening or removing covers may expose you to dangerous voltages.
Incorrect reassembly could cause electric shock if the appliance is subsequently used.
If service or repair work is required, take it to a qualified service dealer.
Damage requiring service
Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following
conditions:
When the power supply or its plug are damaged.

When the attached cords are damaged or frayed.

If liquid has been spilled into the product.

If the product has been exposed to rain or water.

If the product does not operate normally.

If the product has been dropped or damaged in any way.

There are noticeable signs of overheating.

If the product exhibits a distinct change in performance.

5