Installation - Technicolor TG799 Installation Manual

STEP-BY-STEP GUIDE
TO INSTALLING THE HNG
1.
Follow the connection configuration instructions given on the following pages.
The configuration will vary according to the type of NBN connection and the
existing services you have. Your service provider can provide more
information if you are unsure.
2.
Plug the Power Supply Adaptor cable into the HNG power inlet on the back of
the device. Then, plug the adaptor into a power outlet, turn it on, and push the
ON/OFF button to turn the HNG on.
3.
Allow up to five minutes for the HNG to power on and perform the start up
sequence. Various lights will be flashing as the device starts up (see the 'Lights
on the HNG' on page 3 to see their functions). Wait for the status light to remain
solid green before going to the next step. If the status light is not solid green,
contact your service provider for assistance.
4.
If you have ordered a home phone service as part of your NBN connection,
you can now connect your telephone device to either of the two GREEN
phone ports at the back of the HNG using one of the GREY telephone
cables provided.
5.
If you have ordered a broadband service as part of your NBN connection,
you can now connect your PC or laptop to any of the four YELLOW LAN ports
at the back of the HNG using the Ethernet cable (with yellow ends) provided.
If you need to reconnect to your existing working ADSL broadband service
before the changeover to the NBN, you will need to re-activate your ADSL
broadband service using your user ID and password supplied by your current
ADSL broadband service provider.
6.
With your home phone and/or broadband service connected to the NBN
and working, you can now connect your Wi-Fi devices.
The HNG has two Wi-Fi networks: 2.4G and 5G. The factory default
network IDs and passwords for these Wi-Fi networks can be found on
the Wi-Fi information label provided in the box, and on the label attached
to the back of the HNG device. The wireless network ID and password
can be changed via the user interface if you need.
A Wi-Fi connection can be achieved by entering the password
on your wireless device (once the wireless device detects the HNG
wireless network, identified by the network ID), or by pressing the WPS
key on your HNG. Pressing the WPS key on the HNG will put it in Wi-Fi
protected setup mode. You will have approximately two minutes to press
the WPS on the other Wi-Fi enabled device to complete the connection.
7.
To pair your DECT cordless phones (not supplied), and to set up any
other advanced settings available on the HNG, refer to the information
on advanced features which can be found on page 15 of this guide.
Important: Your service provider will provide you with connection configuration
instructions with your HNG that explain how to connect your device. If you have not
received these instructions, please contact your service provider immediately.
6