Canon lpb3360 User Manual page 280

The data lies outside the paper.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
Cause 4
Remedy
Cause 5
Remedy 1 Secure a margin around the data so that it fits within Printable Area (See p.
Remedy 2 If you select the [Print with Upper Left of Sheet as Starting Point] check box in
Cause 6
Remedy
The printing position is skewed.
Cause 1
Remedy
Downloaded from ManualsPrinter.com Manuals
You are using UFR II Printer Driver, and you loaded custom paper of its long
edges 215.9 mm or less and printed when SLOT PAPER SIZE, CASSETTE1
SIZE, or CASSETTE2 SIZE in the FEEDER MENU options in the SETUP menu
was set to MIXED SIZE.
Load the paper in landscape orientation, then print again.
When UFR II Printer Driver was not used, non-standard size paper was loaded
in the landscape orientation to print.
Load the paper in portrait orientation, then print again.
Paper of the size smaller than the data size is loaded.
Load the paper of the size that matches the data size or print the data in the
reduced size that matches the paper size. (See Driver Guide)
The position of the paper is incorrect.
Load the paper properly and print again. (See "Printing from the Paper
Cassette," on p. 4-19, "Printing from the Manual Feed Slot," on p. 4-37)
A document with no margins was printed.
4-7), then print again.
the [Finishing Details] dialog box in UFR II Printer Driver, the printer prints with
its printable area expanded. However, data may be printed with the edges
missing.
The printing position has been adjusted in ADJ.START POS. in the USER
MAIN. options in the SETUP menu.
Adjust the printing position to an appropriate value using ADJ.START POS. in
the USER MAIN. options in the SETUP menu. (See "Adjusting the Printing
Position," on p. 7-22)
GUTTER, OFFSET Y, or OFFSET X in the LAYOUT MENU options in the
SETUP menu is specified.
Set GUTTER, OFFSET Y, or OFFSET X in the LAYOUT MENU options in the
SETUP menu to "0", and then print again.
When You Cannot Obtain Appropriate Printout Results
8
8-43