Canon MG5200 On-Screen Manual page 456

Reprinting Photo on the Disc Label
Advanced Guide > Printing Using the Operation Panel of the Machine
Photo on the Disc Label
D005
Reprinting Photo on the Disc Label
Print an image on a printed photo onto a printable disc.
For MG8100 series only, you can print the image on the film (35 mm negative/positive (strip/slide)) onto a
printable disc.
Important
You cannot print on 3.15 inches / 8 cm printable discs.
Do not attach the Disc Tray until the message asking you to set the printable disc is displayed.
Doing so can damage the machine.
Note
If printing is misaligned, adjust the printing position. For information on how to adjust it, see
Adjusting the Print Area
1.
Display the Reprint from printed photo screen.
How to Select a Photo Reprinting Menu
Note
For MG8100 series only, when you print from film, display the Reprint from film screen.
2. Disc label print, then use the
Select
The print area setting screen is displayed.
3.
Use the button to select Outer circle or Inner circle and use the
change the print area.
4.
Use the button to confirm the selection.
OK
Note
Measure the outer and inner diameters of the printing surface of the printable disc and make
sure you set a value smaller than the measured value for the outer diameter, and a value larger
than the measured value for the inner diameter.
For information on printable discs, contact their manufacturers.
5.
Use the button to select Recommended disc or Other disc, then use the
button to confirm the selection.
The photo selection screen is displayed.
Note
If your printable disc is the recommended disc, specify Recommended disc for the suitable
density printing. If not, specify Other disc.
6.
Use the button to select the photo to print, then use the
the selection.
Note
Downloaded from ManualsPrinter.com Manuals
.
OK button to confirm the selection.
> Using Photo Reprinting Functions
button to confirm
OK
Page 456 of 1037 pages
> Reprinting
button to
OK