Canon MG5200 On-Screen Manual page 913

Error Message Appears on a PictBridge Compliant Device
Advanced Guide >
Troubleshooting
U334
Error Message Appears on a PictBridge Compliant Device
The following are the possible errors that may occur when printing directly from a PictBridge compliant
device and the countermeasures to clear them.
Note
This section describes errors that are indicated on Canon-brand PictBridge compliant devices. The
error messages and operations may vary depending on the device you are using. For errors on non
-Canon PictBridge compliant devices, check the error message on the LCD and take the
appropriate action to clear the error. For details, see
For the errors indicated on the PictBridge compliant device and their solution, also refer to the
instruction manual of the device. For other troubles on the device, contact the manufacturer.
Error Message on the PictBridge Compliant
Device
"Printer in use"
"No paper"
"Paper Error"
"Paper jam"
"Printer cover open"
"No print head"
"Waste tank full"/"Ink absorber full"
"No ink"/"Ink cassette error"
"Ink Error"
Downloaded from ManualsPrinter.com Manuals
> Error Message Appears on a PictBridge Compliant Device
An Error Message Is Displayed on the LCD
If the machine is printing from the computer or
warming up, wait until the job ends.
When it is ready, the machine starts printing
automatically.
Load paper on the Rear Tray, and select
Continue* in the display on your PictBridge
compliant device.
* To resume printing, you can also press the
button on the machine instead of selecting
Continue on the device.
If the Inner Cover is opened, close it and select
Stop in the display on your PictBridge compliant
device to stop printing.
Select Stop in the display on your PictBridge
compliant device to stop printing.
Remove the jammed paper, load new paper,
press the
printing again.
Close the Scanning Unit (Cover) on the machine.
The Print Head is defective or is not installed.
Check: See
Message Is Displayed on the LCD
appropriate action.
The ink absorber is nearly full.
Check: See
Error Message Is Displayed on the LCD
the appropriate action.
The ink tank is not installed properly or empty.
Check the error message on the LCD and take the
appropriate action to resolve the error.
An Error Message Is Displayed on the LCD
An ink tank that was once empty is installed.
Check: See
be correctly detected.
Displayed on the LCD
action.
Action
OK button on the machine, and try
Print head is not installed.
and take the
The ink absorber is almost full.
The remaining level of the ink cannot
in
An Error Message Is
and take the appropriate
Page 913 of 1037 pages
.
OK
in An Error
in An
and take