Ultra Low Power Mode; Sleep Mode - MTX -3G-JAVA series User Manual

Table of Contents

Advertisement

 
5.3 Ultra Low Power mode
MTX‐3G‐JAVA‐ULP  modems  can  enter  into  an  Ultra  Low  Power  mode.  In  this  mode,  all  the  board 
devices are disconnected from the power supply, except a little portion of digital logic and the RTC 
that allows the modem to exit from this mode and go back into the normal mode.  
 
The first time the MTX‐3G‐JAVA‐ULP modem is powered up, it will switch on normally. When an ULP 
modem enters in power down mode, you can wake up again in several ways: 
 
By optoisolated inputs (see Section 4.1.3): there are two active‐high inputs and two active‐
low inputs allowing  the modem to power up again. 
By the RTC alarm (see Section 4.10): you can configure the RTC to power on the modem at a 
specified date and time 
 
It is possible to know if the modem has been woken up by inputs or the RTC alarm by reading the 
status latches with AT commands or the Java application. 
 
WAKEUP input 
Wake‐up 1 
Wake‐up 2 
Wake‐up 3 
Wake‐up 4 
 
Keep in mind that those inputs and the RTC can only be programmed when MTX‐3G‐JAVA‐ULP is in 
normal mode. 
 
The only way to enter in Ultra Low Power mode is to clean/reset the input latches and execute the 
AT^SMSO command. 
 
5.4 Sleep mode
The modems that can disable the Automatic Restart after Shutdown feature are able to enter into a 
sleep mode. In this mode all the electronic systems are powered and enabled, but the GSM engine 
enters  into  a  power  down  mode  where  only  the  module's  internal  RTC  stays  active  (see 
4.10.1). 
 
To enter in Sleep mode, follow these steps: 
1. Disable Automatic Restart after Shutdown 
2. Use  the  AT^SMSO  command  to  disconnect  the  modem  from  the  cellular  network  and 
shutdown the modem 
 
There are several ways to wake up the modem: 
Programming a time/date alarm in the module's internal RTC (AT+CALA command) 
Using TURN_ON signal at the power connector 
With an acceleration threshold interrupt from the internal accelerometer (see Section 4.8) 
www.mtx‐terminals.com 
GPIO number 
GPIO 6 
GPIO 7 
GPIO 8 
GPIO 9 
www.mtxm2m.com 
 
MTX M2M® by MATRIX ELECTRONICA S.L.U 
MTX‐3G‐JAVA Family
2015/10 v1.6  
Section 
/
Page 76
109 

Advertisement

Table of Contents
loading

Table of Contents