MTX -3G-JAVA series User Manual page 106

AT^SISI Internet Service Information
AT^SISO Internet Service Open
AT^SISR Internet Service Read Data
AT^SISS Internet Service Setup Profile
AT^SIST Enter Transparent Access Mode
AT^SISW Internet Service Write Data
AT^SISX Internet Service Execution
AT^SJAM Manage Java Application
AT^SJDL Java Download
AT^SJMSEC Java Midlet Security
AT^SJNET Set Dialup Network Access Parameters
AT^SJOTAP Over The Air Application Provisioning
AT^SJRA Run Java Application
AT^SLED LED Feature
AT^SMGL List Short Messages from preferred store without setting status to REC READ
AT^SMGR Read short message without setting status to REC READ
AT^SMONI Monitoring Serving Cell
AT^SMONP Monitoring Neighbour Cells
AT^SMSO Switch Off EHS6
AT^SNFI Set microphone path parameters
AT^SNFM Set microphone audio path and power supply
AT^SNFO Set audio output (= loudspeaker path) parameter
AT^SNFS Select audio hardware set
AT^SNFTTY Signal TTY/CTM audio mode capability
AT^SNMON Network monitoring
AT^SPIO GPIO Driver Open/Close
AT^SPOW Set UART Mode and SLEEP Mode on UART
AT^SRADC Configure and Read ADC Measurement
AT^SRTC Ring tone configuration
AT^SSCNT Start and Stop Pulse Counter
AT^SSIO Set IO state of a specified pin or port
AT^SSPI Serial Protocol Interface
AT^SSTA Remote‐SAT Interface Activation
AT^SWDAC PWM Signal Configuration for DAC
AT^SXCALLSTAT Set Reporting Call Status
AT^SXEONS Display Eons names
AT^SXRAT Selection of Radio Access Technology
ATA Connect to Incoming Call
ATA Manual acceptance of a network request for PDP context activation
ATD Mobile originated call to specified number
ATD*99# Request Packet Domain Service
ATD><mem><n> Mobile originated call using specific memory and index number
ATD><n> Mobile originated call from active memory using index number
ATD><str> Mobile originated call from active memory using corresponding field
ATDL Redial last number used
www.mtx‐terminals.com www.mtxm2m.com
MTX M2M® by MATRIX ELECTRONICA S.L.U
MTX‐3G‐JAVA Family
2015/10 v1.6
/
Page 106 109