Korg m1r Owner's Manual page 20

Program parameters change as shown in the chart below when selecting positive parameter values("+" settings).
The reverse changes occur when negative values("-" settings) are used.
PROGRAM Mode Parameters Effect of a positive value setting on each parameter
OSC Balance OSC 1 Level The level of OSC I increases, while that of OSC 2 decreases.* 1
OSC 2Level
VDF Cutoff VDF 1, 2 Cutoff Increases (or assumes a positive value). *1
VDALevel OSC 1, 2 Level
Keyboard Track VDF 1, 2 KBD TRK Cutoff Increases in proportion to note number of key played.*2
EGTime
VDA 1, 2 KBD TRK Amplitude
EGTime
Even when set to a negative value, only the absolute value
Velocity OSC 1, 2 EG Level Vel Sens becomes smaller, but the sign("+" or"-") does not change
Sensitivity
EG Time Vel Sens
VDF 1, 2 VEL SENS EG Int
EGTime
VDA 1,2 VEL SENS Amplitude Parameters with values set to "O" remain as "O" and do not
EG Time change.
Attack Time VDF 1, 2 Attack Time Increases (or assumes a positive value). *3
VDA 1, 2 Attack Time
Release Time VDF 1, 2 Release Time
Increases. *1
Effect Balance
EFFECT 1, 2 Balance
* 1 Assuming that the original value= V, then the changed value is increased or decreased by 5V.
*2 Assuming that the original value= V, then the changed value increases by a power of 1 + (V/10).
*3 Assuming that the original value= V, then tJie increase or decrease of the VDF value is by 3V, while that of the
VDA value is by 5V.
19