Korg m1r Owner's Manual page 113

Hide thumbs Also See for m1r:
Table of Contents

Advertisement

*
*
*
*
*
*
*
*
*
*
*
*
*
Selects the function
to
be assigned to
Pedal
1 and
Pedal 2.
Connect footswitch or foot controller to the jack of
Pedal
1
or 2
depending
on the function
to be
selected.
The
range controllable by the
foot
controller
may sometimes
be limited by
the corresponding parameter
settings.
Program Up: Switches to the next Program (or, in PROG/COMBI
Mode, Combination)
by
footswitch.
When this is selected,
MIDI
program
change
data is
sent from MIDI
OUT.
Program
Down:
Selects the previous
Program (or,
in
PROG/COMBI Mode, Combination) by
foots
witch.
SEQ Start/Stop: Starts and
stops
the sequencer by footswitch.
Effect 1 ON/OFF:
Toggles
Effect 1 on
and
off by footswitch.
Effect 2 ON/OFF:
Toggles Effect 2
on
and off
by
footswitch.
Volume: Controls
the
volume of MIR
by foot
controller.
VDF Cutoff: Changes
the
cutoff frequency
by
foot controller.
C utoff frequency
is
raised
by
pressing
down the pedal. (The
sound color
becomes brighter.)
Effect
1 Balance: Determines the overall balance between the direct sound
and
the effect
sound of
Effect
1
by
foot
controller.
The ratio
of the effect
sound to direct sound becomes greater when
pressing
down
the pedal.
Effect 2
Balance:
Determines the overall balance between the direct
sound
and the
effect so
und
of
Effect
2
by foot controller. The
ratio
of the effect
sound
to
direct
sound becomes greater when
pressing
down the pedal.
Data Entry: Allows
changing
and adjustment of parameter
values (usually controlled
by
the
VALUE
dial on the panel)
by
using the foot
controller. The value of
each parameter
can
be
controlled
by
foot
controller while playing if
the
parameters to be changed are selected beforehand.
Make sure
to
match the footswitch/foot controller connection
to the assigned
functions.
We recommend using the KORG EXP-2 for the
foot
controller.
NOTE: When no pedals or footswitches are connected to the rear panel jacks, set this function's parameters to
correspond to footswitch operation functions (Program Up, Program Down, SEQ Start/Stop, Effect ON/OFF).
112

Advertisement

Table of Contents
loading

Table of Contents