Table of Contents
Advertisement
-
- - -
-
Hi Hat
SNARE1
Snare 1 is assigned to all of these keys (the pitch changes accordingly)
.
*
*
*
*
*
*
*
Tune, Level and Decay are the parameters which set the volume, pitch and VDA decay time of each
drum sound.
When changing the corresponding Program parameters, the parameters (volume, for instance) of the
whole Drum Kit change.
Other Program parameters control the entire Drum Kit as well.
Tune sets the pitch of assigned key in the range of -120 to +120 (in IO-cent units,+/- I octave)
.
Level sets the relative value to the oscillator level in the PROGRAM Mode over a range of -50 to +50.
Decay sets the relative value to the VDA EG Decay setting in the PROGRAM Mode over a range of
-50 to +50.
Pan determines the output destination from the selection of A, A:B (9
:
1 to 1 :9), B, C, C + D and D.
F 4 - 2--4 DRUM KIT 2--4
*
Identical to F 4-1 DRUM KIT
1.
F S - 1 MIDI GLOBAL
*
*
*
*
*
*
*
*
*
*
MIDI GLOBi::IL
CH=
1
CLK:INT
Col'1r~on
CH
Local:OFF
A
B
C
0
E
F
C
H
-
. . . . . -
. . . . . 4iiiiiiiiit
4iiiiiiiiit fiiiiiiit tiiiiiiiiiiiit
[fil
Channel
1-16
Input/Output channel of internal play data
@]
Clock Source
INT/EXT
Selection of transmission or reception of MIDI clock for sequencer
@]
Overflow
OFF/ON
MIDI local mode switch
Channel sets the sending and receiving channel of MIDI.
When the type is .set to Multi in the COMBINATION PLAY Mode or when in the SEQUENCER Mode,
MIDI data other than that of channel set here may be handled.
When MID
I
Overflow is set to ON, any incoming on/off note data (either through MIDI IN or the MIR' s
sequencer) wh ich is beyond the 16-note simultaneous polyphonic capability of the MIR is output
through MIDI'OUT for play on external synthesizers.
The simultaneous polyphonic output can be increased by connecting another MIR to the MIDI OUT
terminal.
Make certain that the same Program/Combination is set on both MlRs.
The default setting, or the setting when power is turned on, is overflow OFF.
Clock Source should be set to EXT when receiving the play tempo from external sequencers as MIDI
clock data. (With this setting the internal tempo of MIR is not operative.) This is used to synchronize
with external sequencers and rhythm machines.
Make sure to set this function to INT when other MIDI devices are not connected to MIDI IN.
The MIR will receive start, stop, continue, song select, and song position data from external MIDI
devices only when this function is set to EXT.
The default setting, or the setting when power is turned on, is INT.
115
Advertisement
Table of Contents
