Table of Contents
Advertisement
NOTE:
The
waveforms
of
the PCM
(Multisound)
card are selected in the Oscillator Assign function of the EDIT
PROGRAM Mode and the Drum Kit functions of the GLOBAL Mode.
In
these exceptions,
the
INT Key and
CARD Key are not used.
NOTE: Make certain to insert the card straight and firmly into the correct slot.
Cursor Keys and VALUE Dial
A
8
C D
E F G
HQ)
Parameter values can be changed by pressing the cursor key
below the parameter to be edited on the display, then by
adjusting the VALUE dial.
Cursor keys used to access
different function and parameters will be indicated in
squares (
D )
throughout the rest of this manual.
cc= =1c= IC
=~Ii==
=rr
_
-
_
-_Il
=~=
n
===
JT_-_
=
Ir
UP/DOWN Keys
DOWN
I
I
UP
c=--,
c=)
These are used when finely adjusting the values of parameters that are difficult to set
only by using the VALUE dial or when making fine and detailed alterations in the
sound. Pressing UP increases the value by
I
and pressing DOWN decreases the value
by 1.
*
Concerning the UP/DOWN keys:
The cursor will appear under the Combination/Program number at the bottom left of the screen when pressing
the COMBI key or PROG key of the MODE SELECT keys (immediately after selecting the COMBI or PROG
Mode)
.
Pressing the UP key in this condition will advance the Combination or Program number by one and
pressing the DOWN key will decrease
it
by
one.
*
The VALUE dial cannot be used here to change the Combination or Program
.
*
Pressing any of the cursor keys ( ~ through
!HJ )
will move the cursor to the performance edit
parameters, and editing can be done by using the UP/DOWN keys and the VALUE dial.
To return the UP/DOWN keys to function as Program up and down after selecting the performance edit mode:
in PROGRAM Mode, press the PROG
button;
in COMBINATION Mode, press the COMBI button.
In each case, the cursor will return to its position under the Combination or Program number and the UP/DOWN
keys can
be
used again to increment and decrement the Combination or Program number.
PAGE+/- Keys
PAGE
+
PAGE
C=-=1
I
)
START/STOP Key
INT
CARD
c===i C==>
COMBJ
f
DIT
COMBI
c===i C==>
PROG
EDIT PROG
c===i C==>
SEQ
GLOBAL
c===i C==>
r -
SEQ
------,
START/STOP
REC
[~_-I:::-~::)J
REC Key
INT
CARD
c===i C==>
COMBI
EDIT COMBI
c===i C==>
PROG
EDIT PROG
c===i C==>
SEQ
GLOBAL
c===i C==>
. - -
sea
- - ,
START/STOP
RE
C
[~---~J
Each function of the MIR is organized in display pages. These keys
allow
you to
access succeeding and preceding display pages by using the PAGE
+
and PAGE -
keys, respectively.
·
This key is used to start or to stop the sequencer.
If
you press this key in any
mode other than the SEQUENCER Mode, the MIR will automatically move to
the SEQUENCER Mode and play will start. When the sequencer is playing, the
first beat of the measure is indicated on the key by a flashing red light; other beats
are indicated by a flashing green light.
This key is used
to
begin recording when in the SEQ mode. The lamp remains lit
while the sequencer is running.
I
10
Advertisement
Table of Contents
