Rear Swing Arm; Overhauling; Removal Of Bearings From The Rear Swing Arm; Adjusting The Rear Swing Arm Play - MOTO GUZZI V1000 I-Convert Workshop Manual

REAR SWING ARM
OVERHAULING
Inspect the rear swing arm for abnormal bending
or cracking at welded points, check the con-
dition of bearing seats and the smoothness of
the connecting surface to the rear drive box .
For this inspection see Drwg . 311 .
REMOVAL OF BEARINGS FROM
THE REAR SWING ARM
The cardan Joint bearing is removed using pul-
ler 18927250 (66 in tig. 312): the rear fork pin
148
bearings are removed using puller 1290 47 00
(14 in fig . 125),
ADJUSTIN G THE REAR SWING ARM PLAY
(fig. 313)
The rear swing arm has to swing freely, without
any play.
Pay attention that for proper adjustment the
pins must extend the same length.
For this adjustment use a screw driver .. A ..
and a gauge «B .. ,