Access The Setup Screens - Crestron TS-1542 Supplemental Manual

TS-1542/TS-1542-C:
15.6" HD Touch Screen

Access the Setup Screens

The setup screens enable basic configuration prior to regular operation of the Crestron
TS-1542 and TS-1542-C. To display the main setup screen, touch the screen while
applying power to the unit.
The TS-1542 and TS-1542-C are functionally similar. For simplicity within this guide, the
term "TS-1542" is used except where noted.
NOTE:
screen defaults to the main setup screen.
During regular operation of the TS-1542, there are two ways to access the setup screens:
1. Place a button on the project main page and assign the reserved join number
2. Touch the screen with five fingers simultaneously, for more than 15 seconds.
The TS-1542 Setup screen is displayed.
TS-1542 Setup Screen
The TS-1542 Setup screen is composed of buttons for Ethernet setup, IP table setup,
audio setup, display setup, standby timeout, and diagnostics. In addition, there is a button
to toggle system messages on or off. An About button provides information about the
touch screen, and a Save & Exit button saves settings and exits the setup screens. The
functions of each are detailed in the following pages of this guide.
Supplemental Guide – DOC. 7824B
If no project has been loaded or if an invalid project has been loaded, the touch
(17242) that accesses the setup screens.
TS-1542/TS-1542-C: 15.6˝ HD Touch Screen • 1
®