Programming The Temperature Via The Pid-Display - Profitec Pro 700 User Manual

Bedienungsanleitung / User manual Pro700
If you would like to plumb your machine, installation through a qualified service
technician is required.

6.2 Programming the temperature via the PID-display

During normal operations the temperatures of the coffee boiler (t1, left dot on the display) and the steam
boiler (t2, right dot on the display) are indicated alternately.
The controls are factory pre-set so that both boilers are heated consecutively, whereby the coffee boiler (t1)
has priority. This means that the steam boiler (t2) is activated only after the programmed temperature of the
coffee boiler has been reached.
If you prefer simultaneous heating of both boilers, please contact your authorized service dealer for re-
programming the PID-control.
Switch the machine on in order to activate both boilers (switch in position
"2"). The temperature of either boiler is of no importance in programming.
Both heaters are inactive during programming.
+ –
2. Press and at the same time until 't1' (coffee boiler) appears on the
display,
+
3. Press in order to progress to the submenu of 't1' and to change the
temperature value. The nominal temperature value is displayed.
4. Quickly press
-
+
the nominal temperature value.
5. Please wait a short while after having set the nominal temperature value;
't1' will be displayed
-
6. Press in order to display 't2' (steam boiler). If you would like to change
just 't2' and leave 't1' unchanged, press
directly to 't2' and skip 't1'. Continue with step 7.
+
7. Press in order to progress to the submenu of 't2' and to change the
temperature value. The nominal temperature value is displayed.
8. Quickly press
the nominal temperature value.
9. Please wait a short while after having set the nominal temperature value;
't1' will be displayed.
to decrease
to increase
–
after step 2 in order to progress
-
to decrease
+
to increase
25