Table of Contents
Advertisement
Using the Management Port
Logging In to the Switch
Default Configuration Files
60
G8124-E Installation Guide
The console port terminal-emulation requirements are as follows:
•
Default baud rate = 9,600 bps
•
Character size = 8 characters
•
Parity = none
•
Stop bits = 1
•
Data bits = 8
•
Flow control = none
If the switch is connected to a network that employs DHCP, you can also access the
switch CLI through the RJ-45 management port. This port uses Ethernet
communications and can be accessed using Telnet, SNMP, or a Web browser via
the IP address provided by the network's DHCP server.
When the switch starts, it performs initial self tests, and then prompts for the
password. For example:
Memory Test ................................
Production Mode
PPCBoot 0.0.0.10 (new flash)
Memory Test (0x00) .............................PASSED
...
Lenovo RS G8124-E
Jan 6 00:11:36 2015:
Password:
At the prompt, type the switch password and press Enter. The default is admin.
Note: If the switch has already started prior to your connection, you may need to
press Enter to display the password prompt.
The switch firmware contains default configuration files that are loaded at the
factory. When the switch first initializes, the default configuration files are loaded into
the active switch memory. The default settings allow the switch to perform basic
functions with minimal effort by the system administrator.
Custom configuration settings made by the administrator will override the default
settings and can be saved so that they are retained if the switch is rebooted.
However, if desired, you can revert the custom configuration settings to the original
factory defaults. The original factory default configuration files are a permanent part
of the firmware; you cannot deleted them or change their original definitions.
Hide quick links:
Advertisement
Table of Contents
